If this parameter is omitted, this command prints the selected information only once. Redisplays the selected information every interval seconds. This is equivalent to the route print command.
The -p parameter can be used to specify a set of protocols.ĭisplays the contents of the IP routing table. If the IPv6 protocol is installed, statistics are shown for the TCP over IPv6, UDP over IPv6, ICMPv6, and IPv6 protocols.
By default, statistics are shown for the TCP, UDP, ICMP, and IP protocols. If this parameter is used with -s to display statistics by protocol, Protocol can be tcp, udp, icmp, ip, tcpv6, udpv6, icmpv6, or ipv6.ĭisplays statistics by protocol. In this case, the Protocol can be tcp, udp, tcpv6, or udpv6. Shows connections for the protocol specified by Protocol. This parameter can be combined with -a, -n, and -p.
Portexpert windows#
You can find the application based on the PID on the Processes tab in Windows Task Manager. This parameter can be combined with -s.ĭisplays active TCP connections, however, addresses and port numbers are expressed numerically and no attempt is made to determine names.ĭisplays active TCP connections and includes the process ID (PID) for each connection. Note that this option can be time-consuming and will fail unless you have sufficient permissions.ĭisplays Ethernet statistics, such as the number of bytes and packets sent and received. In this case the executable name is in at the bottom, on top is the component it called, and so forth until TCP/IP was reached. In some cases well-known executables host multiple independent components, and in these cases the sequence of components involved in creating the connection or listening port is displayed. Syntax netstat ĭisplays all active TCP connections and the TCP and UDP ports on which the computer is listening.ĭisplays the executable involved in creating each connection or listening port.
Portexpert code#
Mastercam generates 5-axis code that can run any CNC machine.This command is available only if the Internet Protocol (TCP/IP) protocol is installed as a component in the properties of a network adapter in Network Connections. Mastercam's simulation proceeds step-by-step through the toolpath, even showing you the motion used in transition at the middle of the port. Port Expert creates toolpaths on triangulated or stitched surfaces, a one-piece surface is not necessary. Port Expert automatically calculates optimal tilt angles so there is no need to split the surface or create tool axis control splines. And, since Port Expert can support unlimited surfaces, the geometry can be made of multiple surfaces that are stitched together.Īdditional features of Port Expert include: Port Expert provides both roughing and finishing toolpaths to make ports from castings or billets. This leaves no fishtails or inefficient reverse moves, and smoothly transitions where the toolpaths meet at the middle of the port. The Port Expert toolpaths use 3-axis machining as far into the port as possible, and then convert automatically to 5-axis motion with minimum tilt. Specify how much stock to leave on the entire port There are multiple cutting options available with Port Expert. Port Expert uses a lollipop tool, and has collision checks for the entire tool (shank, arbor, and holder). CNC Software/Mastercam's new Port Expert add-on creates accurate, efficient engine cylinder head porting toolpaths on port surface or solid data.
0 kommentar(er)
